Messages

11

LazyCam (Beta) / Re: OK, I give up! How do I get ACAD dxf files to open in LCAM 2.02?

« on: August 26, 2007, 09:20:01 AM »

I found that I  must save, then close the dxf. file on acad before it will open an lazycam.

12

General Mach Discussion / stuck on external estop

« on: June 30, 2007, 03:56:13 PM »

i just purchased digital Rockcliff cnc machine plans over the net and the Mach3  software was included. Iam totaly new at cnc software and working  with it to get to know it, nothing seems to work . its constantly asking for an external Estop on the bottom left hand corner.?
I have no hardware hooked up, and the reset botton is useless?   somebody help me.
also looking to start building a small cnc router and help selecting hardware would be appreciated.

thanks ticoe