1
General Mach Discussion / Re: Slow jogging
« on: June 20, 2018, 01:38:25 PM »
Hello!
I have exactly the same problem SteinarN has.
I am running Mach3 on Windows 7 64bit in DEMO mode. (Ver. 3.043.066)
The Motor has 1000 unit/min parameter.
I got only 168 unit/min (about 1/6 (16.8%) of the maximum) in Jog mode 100% "Jog Rate".
I have no printer driver installed, I just "playing" with Mach3.
How is it possible to force Mach 3 to increase this 16.8%?
Thank you in advance!
I have exactly the same problem SteinarN has.
I am running Mach3 on Windows 7 64bit in DEMO mode. (Ver. 3.043.066)
The Motor has 1000 unit/min parameter.
I got only 168 unit/min (about 1/6 (16.8%) of the maximum) in Jog mode 100% "Jog Rate".
I have no printer driver installed, I just "playing" with Mach3.
How is it possible to force Mach 3 to increase this 16.8%?
Thank you in advance!