1
Mach4 General Discussion / Re: Moving off home switch during RefAllHome ? (Mach4)
« on: November 12, 2020, 07:56:28 AM »
Hello bob.
I have a question about offset in machine vs mach4 coordinates.
On 12 inches jog there is round about 1 inch offset. On 24 inch jog there is 2 inches offset.
How can I synchronize my machine movement with mach4 jogging. My design can tolerate +/-2mm offset. But not more than that.
Aqsa
I have a question about offset in machine vs mach4 coordinates.
On 12 inches jog there is round about 1 inch offset. On 24 inch jog there is 2 inches offset.
How can I synchronize my machine movement with mach4 jogging. My design can tolerate +/-2mm offset. But not more than that.
Aqsa