4
« on: July 14, 2016, 08:38:05 PM »
I'm having a couple of problems with G-Code coming out of Fusion 360. It runs fine - BUT, after the code has run, my MDI no longer works, and the machine won't run the Mach Blue Z-axis zeroing routing correctly - it finds the plate, and then pauses, and then crashes DOWN again!!!! I've wreaked a couple of end mills this way. Both the Z probing and the MDI work fine before I run the code from Fusion, but not after. They also work before or after I run code from CamBam.
Now, I'm no expert at G-code, but I'm assuming there is some command which is switching off the MDI, and that is somehow effecting the Z probe code as well. After the Z-probe fails, there is a message about an error in line 19 (I believe - I don't remember the exact details).
Any help would be great!
Gabriel