Topics

1

General Mach Discussion / Ahha driver and Mach 3

« on: March 19, 2006, 12:23:55 AM »

I decided to upgrade my AHHA retrofit from the Artisan software to the Mach 3 controller mostly because i heard good things about constant velocity with Mach 3.  I have had no luck with getting it up and running.  I'm almost 100% sure that the pin outs I have in the instruction manual and have downloaded from the net are not correct for the driver I have!

Can anyone tell me where to get pinouts for a RC500 12-2?  I have customers waiting on parts and my machine is down until I get the new controller to work.