Guest
Show Posts
1
General Mach Discussion / Y axis movement opposite.
« on: July 12, 2016, 12:15:42 PM »
Hi All,
Need mach3 expert help.
I recently retrofit an old IRIS engraving machine and setup using mach3.
Attached are pic1 = machine layout. I able to setup the X, Y home at upper left with the help of Y home offset.
But when i press the UP arrow key for movement Y=up the it goes down and Down arrow key movement Y goes down.
I tried to reserve it by checking the "reserve" enable mode it goes the same way as the arrow key but all the image to engrave cutted in an inverted image.
May I know is there any setting i made wrongly? PIC3 and PIC4 are my setting.
Please advise.
Need mach3 expert help.
I recently retrofit an old IRIS engraving machine and setup using mach3.
Attached are pic1 = machine layout. I able to setup the X, Y home at upper left with the help of Y home offset.
But when i press the UP arrow key for movement Y=up the it goes down and Down arrow key movement Y goes down.
I tried to reserve it by checking the "reserve" enable mode it goes the same way as the arrow key but all the image to engrave cutted in an inverted image.
May I know is there any setting i made wrongly? PIC3 and PIC4 are my setting.
Please advise.