Hello Guest it is November 19, 2019, 09:24:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lcs2000

Pages: 1
1
General Mach Discussion / Re: Y axis movement opposite.
« on: July 15, 2016, 08:53:09 PM »
Thanks Davek0974 and ger21. 
Now base on the cutting tool view perspective, I able to understand this opposite movement of Y axis.

Am I able to say that all moving bed mill engraving machine, the Y axis setting for mach3 is this configuration which is different from moving gantry mill?

Because i have another Newing Hall engraving machine to be retrofit with Z-axis stepper which is moving gantry mill type to run using mach3.

Appreciated all the people who advise and guide me. Thanks.

2
General Mach Discussion / Re: Y axis movement opposite.
« on: July 15, 2016, 01:34:43 PM »
Hi Ger21,

Thanks for the fast reply.

X is move from left to right +
Y is ( moveable plate ) down to up +  but the keyboard arrow down key pressed, the plate movement is up.

I using Aspire 4.5, origin i use center. i only assign the space bar as E-stop.

3
General Mach Discussion / Re: Y axis movement opposite.
« on: July 15, 2016, 01:16:02 PM »
Hi Jarhead,

I tried the method but the cut out image is inverted.
Any idea how this works?  possible of my cabling need to invert?

4
General Mach Discussion / Y axis movement opposite.
« on: July 12, 2016, 12:15:42 PM »
Hi All,

Need mach3 expert help.
I recently retrofit an old IRIS engraving machine and setup using mach3.
Attached are pic1 = machine layout.  I able to setup the X, Y home at upper left with the help of Y home offset.
But when i press the UP arrow key for movement Y=up the it goes down and Down arrow key movement Y goes down.
I tried to reserve it by checking the "reserve" enable mode it goes the same way as the arrow key but all the image to engrave cutted in an inverted image.
May I know is there any setting i made wrongly?  PIC3 and PIC4 are my setting.
Please advise. 

Pages: 1