Messages

21

General Mach Discussion / Z-Zero problem

« on: July 07, 2016, 10:46:06 PM »

Using MACH 3 version R3.043.062 USB Smooth Stepper, PMDX 126 BOB and 134 Mother Board.  Since changing over to the smooth stepper I must load a cut file into Mach before I can Z-Zero the spindle or use any of the icons on the 2010 Screen Set.   Is there something I need to change in MACH or is this a Smooth Stepper issue?

Thanks
Bill I

22

Mach Screens / 2010 Screen Set Macro assistance

« on: July 07, 2016, 07:23:53 PM »

Just setting up the 2010 Screen Set and I need some assistance. When editing the macros for Ref X,Y and Z where do you plug in the number  0 .9219?  This is the distance from the proxi. switch to edge of the spoil board.

DoButton(23)
'Code "G53 G0 Y1"
'While IsMoving()
'Wend

Thanks
Bill I

23

General Mach Discussion / Re: Settings screen not active

« on: July 05, 2016, 08:19:09 AM »

Found the problem !!

Had to change the power management in the USB port.

24

General Mach Discussion / Settings screen not active

« on: July 01, 2016, 07:36:59 PM »

Using mach3 latest version USB Smooth Stepper. When In open up the setting screen and attempt to use the Axis calibration to set the steps per unit I click on the button and then click any axis I am prompted to enter the distance I enter the distance click OK nothing happens. I pushed the arrow keys to move any axis nothing moves.  Also the reset is not activated. What do I need to do to get he Settings screen to work?
Thanks Bill