1
General Mach Discussion / Re: CNC router suddenly stopped. Please help.
« on: June 18, 2016, 12:59:03 AM »
I checked that and it looks all good. Correct corresponding numbers and still zero movement.
I am not very computer savvy but can do enough to get buy.
Is it one of the following -1. Equipment failure of control electronics( I have replaced lead and breakout board) so I think not likely.
-2. Computer( P.C) failure as I purchased a simple second hand desktop P.C. for mach3 loading and CNC router use.
-3. Idiot operator ( myself) somehow de activating a critical part of either computer or Mach3 causing system not to operate.
Once again I will mention that this CNC router worked fine until only recently when I was having issues loading gcode.
I am not very computer savvy but can do enough to get buy.
Is it one of the following -1. Equipment failure of control electronics( I have replaced lead and breakout board) so I think not likely.
-2. Computer( P.C) failure as I purchased a simple second hand desktop P.C. for mach3 loading and CNC router use.
-3. Idiot operator ( myself) somehow de activating a critical part of either computer or Mach3 causing system not to operate.
Once again I will mention that this CNC router worked fine until only recently when I was having issues loading gcode.