Hello Guest it is May 20, 2024, 08:47:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - BlackBox

Pages: 1

First post. Been using Mach3 for a couple of years with Gerry's 2010 screen set on my large router. Awesomeness!

Today I have a problem. I am converting my small CNC router to be Mach3 compatible via parallel port. I removed the USB motion controller to use it on another machine.
When I do the motor tuning the axis moves smooth as expected - I have tested a range of velocities and acceleration all with no problem.
As soon as I close the motor tuning window and try to jog or run gcode the axis moves with grinds, jerking and stalls.

Any ideas?

Pages: 1