Messages

371

Mach4 General Discussion / Re: input signals

« on: March 25, 2019, 02:50:28 PM »

Craig,

I know I sound crazy but now it works.
The only thing I can think of is maybe I did not exit Mach so a new Lua.mcc could be written.
I am very sorry for taking up your time on this.

Bill

372

Mach4 General Discussion / Re: input signals

« on: March 25, 2019, 02:28:12 PM »

Craig,

I give it a shot.

Bill

373

Mach4 General Discussion / Re: input signals

« on: March 25, 2019, 01:51:51 PM »

Craig,

Only as a homing switch.

Bill

374

Mach4 General Discussion / Re: input signals

« on: March 22, 2019, 05:59:40 PM »

Craig,

Normally I would agree with you.
But the switch works fine for a homing switch.

Bill

375

Mach4 General Discussion / Re: input signals

« on: March 22, 2019, 04:59:05 PM »

Craig,

It does not make any difference.

For some reason it always enters the If-Then loop

Bill

376

Mach4 General Discussion / Re: Is there a Gcode command to reference all axis home?

« on: March 22, 2019, 03:30:45 PM »

My only problem with the G28.1 is the speed is very slow.
I can not find how to change the speed.

377

Mach4 General Discussion / Re: input signals

« on: March 22, 2019, 03:28:58 PM »

Craig,

Yes I have and it does not matter if the switch is active or not.
It enters the If-Then loop.
Trying to read as much on how signals word as I can I saw something about needing to put something in the screen load.
Is that maybe what I am missing?

Bill

378

Mach4 General Discussion / Re: Is there a Gcode command to reference all axis home?

« on: March 22, 2019, 09:33:17 AM »

I am using the
G91 G28.1 X 0.00 Y 0.00
G90
in M4 and it works great.

Bill

379

Mach4 General Discussion / Re: input signals

« on: March 22, 2019, 08:37:33 AM »

Craig,

The parts at the start and end are in the actual code.
It all works other than the part I mentioned.
Here is the whole thing.

380

Mach4 General Discussion / Re: input signals

« on: March 21, 2019, 04:16:55 PM »

jbuehn,

That is one of those things I do not know how to check or see.

The error code stuff is still so far above my head that I might see the fact that there is error code.

bill