Hello Guest it is March 29, 2024, 08:01:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Belnald

Pages: 1
1
I am having communication issues with the seller. Language barrier and all.  The DDCM6V board I bought has different labels for its terminals.  No surprise there.
 So  What do the following labels stand for?  S 0  : S 1  : S 2  :  S 3  : Z_Se  : Y_Se  : X_Se  : 

2
OK then,  I should be good to go.  I'll post the results after I try it out.

3
I know I can run the Mach3 software on Win7 Pro 32-bit.  But as I said in my first post, I upgraded my system to 64-bit.  And the Mach3 page reads like it will not run properly  on a 64-bit system.  Or is that only if I an using a Parallel port, instead of the USB port I plan on using.

4
It is good to hear that the board will work with Mach3 from you (as well as the seller).   So,  How well will Mach3 run on a Win7 pro  64-Bit system?

5
I recently purchased a DDCM6V5.0 Breakout Board on EBay.  before it arrived, I updated my system to 64-Bit.  As Mach-3 will not run on a 64-Bit I plan to use Mach-4.  However, the disk that came with the Breakout Board has all I need to run on Mach-3, but Mach-4.  It seems I need a Plugin file that I dont have.   Does anyone have this file?  I am waiting to hear back from the Company I bought the board from, but am impatient.    Thanks

Pages: 1