Messages

11

Mach4 General Discussion / Re: Mach4 Touch Sceen

« on: May 09, 2020, 07:56:15 AM »

Mike,
Are you referring to Machine Home, or work cords Zero?

Rob

12

Mach4 General Discussion / Mach4 Touch Sceen

« on: May 08, 2020, 07:10:14 PM »

Wanted some feedback on this Screen for Mach4  it is intended to be a very touchscreen friendly 4X Mill screen.  Any ideas, comments, or suggestions will be helpful.

Thanks,

Rob Gaudette
Newfangled Solutions

13

Mach4 General Discussion / Re: Dust hood

« on: May 28, 2019, 04:56:05 PM »

The router profile that comes with Mach4, will come with  dust hood already set up in it.  there is a button on the screen with outputs, and macros in the macros folder.  You will just need to map what you have.

14

Mach4 General Discussion / Re: Dust hood

« on: May 28, 2019, 04:53:24 PM »

If you use the router profile that comes with Mach4, you will have outputs and macros for a dust hood already built in.

15

Mach4 General Discussion / Re: Coordinate Rotation

« on: January 23, 2018, 09:17:20 AM »

It appears to be your macros.  I removed them and your code ran rotated until I canceled it.  Take a look inside your the macros you are running here and see if there is anything that may be canceling the rotation.

16

Mach4 General Discussion / Re: Coordinate Rotation

« on: January 23, 2018, 09:15:58 AM »

It appears to be your macros.  I removed them and your code ran rotated until I canceled it.  Take a look inside your the macros you are running here and see if there is anything that may be canceling the rotation.