Hello Guest it is March 28, 2024, 10:37:59 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mtabernig

Pages: « 1 2
11
Thank you all. I reinstalled mach3 and i had problems with the motors again for some reason, I replace the motors with ones that have more power and work find even with the current cut way down. I think that I burnt the original motors when I live the idling for long times with the machine on but not having anything moving.
Is any command to cut power to the motors after the end of the code? 

12
Thank you

13
yes, it is exactly like that.

14
The serial port  on the newer computers disappear, however, I connected the serial port to a UB100" or some near that name" to convert the serial port to a parallel port and be able to assign the pin numbers to the proper port and pins. I did not that existed and I was trying  to use an old computer with windows XP. Now I am using a new Dell with windows 10 and the adaptermention above.

15
Thank you for the response. However I am using a new computer with a serial port in lew of a parallel port and I had a problem installing the EU 100  or a similar name and someone help me with that. If I remove everything i will have the same problem. I just like to reset all defaults and be done, if that is possible.

16
I wanted to include some information. Everything wha sort of working then I started to get the end tops, the hard stops, to work now I can't get nothing to move.     I would like to reset the entire software to the original default....desperate here!!
I work with the demo version of Mach3 for 4 years and nothing like this had ever happened. I am a hobbyist and I decided to take a plunge and purchase the software if Only can start over.

17
I purchased a new mach 3 and after tuning motors and edge stops  I can get nothing to work and everything is getting worst. I like to know if there is a way to reset the entire software to factory default and restart all the calibration again.
I will really be appreciative about any solution.

18
Mach4 General Discussion / general question
« on: May 16, 2016, 09:09:29 PM »
Wnen i press a jog button you can see the change on screen but the motors do no move do not move.
A few other things do not work like : start from here, run backwards. Yes all the jogs are on in all screens.
The machine run all g code programs. It is just the jogging that it do not work and  is very annoying to turn the motors by hand every time to set up and zero.
Please help.
Mark

Pages: « 1 2