1
G-Code, CAD, and CAM discussions / Homemade table with Mach 3 torch not coming on
« on: December 17, 2020, 08:26:12 PM »
I finally got my table running.
Inkscape
Sheetcam Mach3 post processor
Hypertherm 45xp
Home made table
Mach 3 software.
Yesterday I made my first real cut but I had to start the torch manually. It will not come on automatically as it should.
It does shut itself off at the end of the run.
I do not see a M3 code at the beginning of the program as someone on plasmaspider forum suggested.
Inkscape
Sheetcam Mach3 post processor
Hypertherm 45xp
Home made table
Mach 3 software.
Yesterday I made my first real cut but I had to start the torch manually. It will not come on automatically as it should.
It does shut itself off at the end of the run.
I do not see a M3 code at the beginning of the program as someone on plasmaspider forum suggested.