Messages

11

Mach4 Videos / MACH4 HICON INTEGRA

« on: September 04, 2017, 03:41:08 PM »

HI do any one have screen shots of how to set up the inputs and outputs on mach4 and Integra board I don't understand the manual how to set up the board to be able to use the motors I have a plasma table but I don't think that is a difference I can't make any of my motors move I'm using micro steppers drivers after the Integra they light up but no luck moving the motor thanks,
screen shot will be great thanks

12

Mach4 Toolbox / Re: MACH4 tool change

« on: August 28, 2017, 12:00:44 PM »

i put the tool number on the 3 spaces and know it work thank you very much

13

Mach4 Toolbox / Re: MACH4 tool change

« on: August 27, 2017, 07:59:10 PM »

Hi thanks for your help do I need to change the active D and H on Tool Information
I change the tool to the number 3 and still getting the tool change message
thank you very much for your help

14

Mach4 Toolbox / Re: MACH4 tool change

« on: August 22, 2017, 12:20:09 PM »

thanks for the info and what do i do next
what do i need to ride
my tool on sheetcam is number 3 thanks
is a plasma no idea if i need to change the name on the tool

15

Mach4 Toolbox / MACH4 tool change

« on: August 21, 2017, 03:25:53 PM »

Hi i'm new to mach4 and cant find how to fix this problem anywhere so hope some one can help me
i have a plasma table and using mill

MACH give me this window when i try to run my gcode

A tool change has been requested via
M6. Change your tool then press
Cycle Star to continue

well i dont know where or what to do
the gcode run with no problem on mach3

i'm using a Hicon integra board
thanks

16

HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150

« on: May 23, 2016, 07:37:03 PM »

HI i did not found where to post so my question is I'm about to buy mach4 i have mach3 with proma THC 150 and GEOKO 540 want to upgrade to mach4 i have a plasma table with hypertherm 1000  any idea if the promo THC 150 can be set up to mach4 or
thanks