Messages

1

General Mach Discussion / Re: Set Override/ Feedrate to 100%, or ignore it completely during auto zeroing.

« on: April 16, 2016, 09:46:15 AM »

Hi ger21 and Hood, thanks to both of you!

I used the M48 and M49 as I understand what it does and it does not change my feed rate value. works!  thanks a lot and have a nice weekend,

Georg

2

General Mach Discussion / Set Override/ Feedrate to 100%, or ignore it completely during auto zeroing.

« on: April 15, 2016, 08:55:41 AM »

Hi everyone,

I've got a problem.
I activated auto tool zeroing in mach3 with a tool length sensor.
the problem now is, that even the tool zeroing macro respects the override/ feed rate. so, of course, the Z value depends on the feed rate, as the computer and mach3 need some time to react on the sensor.
As I am a fan of foolproof solutions :-) I want to tell the macro to ignore the override/ feedrate. In case of need it would be possible to include the command to reset feed rate to 100%.

is that possible?

many thanks in advance and best regards

Georg