71
General Mach Discussion / Re: Installing Mach3 on a Dynamite 2800 machine
« on: July 01, 2007, 06:46:26 PM »
Jeff
I understand that Mach III will take over as the controller when I do my installation, but I would like to know what will remain of the old drop in controller and wire from the original machine. Did you discard it? If so it looks like a good location for me to mount a box with my FANUC rotary pulse generator and/or flat screen, etc.
I think I will move forward using my current driver boards and get this machine going. I can always upgrade again next year when Gecko has perfected those new drivers with the opto feed back. Thank you.
Fred
I understand that Mach III will take over as the controller when I do my installation, but I would like to know what will remain of the old drop in controller and wire from the original machine. Did you discard it? If so it looks like a good location for me to mount a box with my FANUC rotary pulse generator and/or flat screen, etc.
I think I will move forward using my current driver boards and get this machine going. I can always upgrade again next year when Gecko has perfected those new drivers with the opto feed back. Thank you.
Fred