Hello Guest it is March 28, 2024, 02:55:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - PenguinAir

Pages: 1
1
General Mach Discussion / Re: 8 position lathe toolchanger
« on: January 30, 2017, 10:20:37 AM »
Thanks Bigwing

2
General Mach Discussion / Re: 8 position lathe toolchanger
« on: January 26, 2017, 01:03:47 PM »
BIGWING
THANKS FOR THE HELP.
RICHARD

3
General Mach Discussion / Re: 8 position lathe toolchanger
« on: January 25, 2017, 04:21:30 PM »
HI Bigwing

I also have a turn 120.  I would like to know how much voltage is used for the sensors and on what pins it uses.
Thanks
Penguinair ;)

4
Thanks Everybody
Richard

5
Third party software and hardware support forums. / UC100 & KL-DB25-5
« on: April 15, 2016, 01:18:52 PM »
Hi
 
I have a UC100 and the green and blue light are on.
It is connected to a KL-DB25-5 Breakout Board.
The board is power by the USB cable supplied with it.
The board has a red light on. I tried to connect just the e stop switch to it.
P10 to ground.
It does not work for me. As you can tell I am very new to this.
 ???Thanks for any help you provide
Richard

Pages: 1