Messages

11

HiCON Motion Controller / Re: Mach4 + Hicon7766 + SheetCam post processor file

« on: April 18, 2016, 11:45:17 AM »

Received this info from the SheetCAM team.

The 'Mach3' post should work. If you are plasma cutting use the 'Mach3 plasma' post

12

Post Processors / Re: Mach4 +SheetCam post processor file

« on: April 18, 2016, 11:43:46 AM »

Received this info from the SheetCAM  Team. Thx.


The 'Mach3' post should work. If you are plasma cutting use the 'Mach3 plasma' post

13

Post Processors / Mach4 +SheetCam post processor file

« on: April 16, 2016, 04:58:31 AM »

Hi all,

Need some support over here. I´m new on this and any help is appreciated.

Building from scratch a plasma CNC using the Hicon 7766 and mach4 SW.

Installed SheetCAM and was asked for the post processor file. I´ve searched without success. Does this file exist? if so can you help me?

Thx, Joao

14

HiCON Motion Controller / Mach4 + Hicon7766 + SheetCam post processor file

« on: April 15, 2016, 06:43:15 PM »

Hi all,

Need some support over here. I´m new on this and any help is appreciated.

Building from scratch a plasma CNC using the Hicon 7766 and mach4 SW. Has been a challenge but, so far so good with the great support of Marc from Vitalsystems.

I´ve now a new issue:
Installed SheetCAM and was asked for the post processor file. I´ve searched without success. Does this file exist? if so can anyone help me?

Thx, Joao