Messages

31

General Mach Discussion / Re: Motor tuning

« on: September 18, 2016, 04:32:33 PM »

I am running mach3 on windows 10

32

General Mach Discussion / Motor tuning

« on: September 18, 2016, 04:21:58 PM »

My home got hit by lightning so I had to buy a new computer. I got everything off my hard drive. The only screen  that will not come up is motor tuning. What can I do?

33

General Mach Discussion / Re: Homing

« on: August 09, 2016, 07:26:37 PM »

? I don't know I didn't build the cnc. I got it working goog so far I had to increase the debounce to 8500 seems to be working fine now

34

General Mach Discussion / Re: Homing

« on: August 09, 2016, 04:52:22 PM »

How can I make it come farther away from the limit switch in z when I ref home

35

General Mach Discussion / Re: Homing

« on: August 09, 2016, 03:49:32 PM »

Thank god that's it hope I got another one

36

General Mach Discussion / Re: Homing

« on: August 09, 2016, 12:12:12 PM »

When I set the index debounce to 4 it works the best. It will work once then not work

37

General Mach Discussion / Re: Homing

« on: August 09, 2016, 12:09:36 PM »

K 4030 Kelinger tec

38

General Mach Discussion / Re: Homing

« on: August 09, 2016, 08:05:44 AM »

The switch is good I tried 1 2 3 4 5 works best at 4 but 1 time it will work the next time it doesn't. I upgraded from windows 7 which it worked fine then I upgraded to windows 10 now it doesn't.

39

General Mach Discussion / Re: Homing

« on: August 09, 2016, 05:22:22 AM »

The  x and y work fine  it is just the z axis

40

General Mach Discussion / Re: Homing

« on: August 09, 2016, 05:21:03 AM »

I tried that and it works then I go to try it again and it doesn't