Messages

21

General Mach Discussion / Re: Big trouble

« on: January 11, 2017, 05:19:29 PM »

I am trying to find where I am getting the noice from. I will let you know how I make out

22

General Mach Discussion / Re: Big trouble

« on: January 07, 2017, 09:52:27 AM »

I ran a different gcode and it happened again but with a different axiz. What is up

23

General Mach Discussion / Re: Big trouble

« on: January 07, 2017, 09:42:27 AM »

I closed mach and reopened it. Everything seems to be working fine now. I checked the wires no problems. I don't know why I got the glitch but it okay now. Any ideas.

24

General Mach Discussion / Re: Big trouble

« on: January 07, 2017, 09:02:15 AM »

I wonder if my shield ground came off at the bob for the axis I am having trouble with

25

General Mach Discussion / Re: Big trouble

« on: January 07, 2017, 08:59:08 AM »

I can't it trips without moving

26

General Mach Discussion / Re: Big trouble

« on: January 07, 2017, 07:03:30 AM »

Okay I will check this morning. I will let you know how I make out  thanks

27

General Mach Discussion / Re: Big trouble

« on: January 07, 2017, 06:57:06 AM »

No I was running a gcode and a limit tripped. I was just air cutting.  My switches are nc in the diagnostic screen there is no lights lit to tell me a limit has tripped

28

General Mach Discussion / Big trouble

« on: January 06, 2017, 08:14:27 PM »

Hi all. I am new to the cnc but my limit switch keeps tripping every 10 seconds approximately.  Even though no axis is even need the limit switches. So I go to the diagnostic screen and nothing is lit up. I then go to con fig /pots&pins/input and start x ing the limits until I stop getting the limit warning. It seems to be in the y axis and I don't know why I am getting this all of a sudden for no reason. Can anyone help me I'm out of ideas.

29

General Mach Discussion / Re: Motor tuning

« on: September 21, 2016, 06:29:18 PM »

We just copied it from the old hard drive. We don't know if it was cerupted or not.

30

General Mach Discussion / Re: Motor tuning

« on: September 18, 2016, 04:45:52 PM »

I got lots of ram and storage twice as much as a normal computer