1
General Mach Discussion / computer updated and now no stepper movement
« on: September 14, 2017, 01:00:50 PM »
hello
I used my cnc machine (g0704) Monday night. Wednesday morning at 3am my designated computer that runs mach3 updated and had an issue rebooting. I fixed the reboot issue and now my c10 breakout board is getting power through the printer port cable dimly energizing the breakout board, when the actual power to it is off. When I turn the power on for the BOB, my driver lights and BOB lights turns real bright(normal operation). mach3 settings are the same...dro's move when commanded but no motor movement and the relay for my air solenoid is stuck on also... maybe printer port went bad? please help if possible. thanks in advance
Jason
I used my cnc machine (g0704) Monday night. Wednesday morning at 3am my designated computer that runs mach3 updated and had an issue rebooting. I fixed the reboot issue and now my c10 breakout board is getting power through the printer port cable dimly energizing the breakout board, when the actual power to it is off. When I turn the power on for the BOB, my driver lights and BOB lights turns real bright(normal operation). mach3 settings are the same...dro's move when commanded but no motor movement and the relay for my air solenoid is stuck on also... maybe printer port went bad? please help if possible. thanks in advance
Jason