1
Share Your GCode / 90 degree sharp turns
« on: February 22, 2016, 12:55:15 PM »
Hello,
Hope someone can advice me please.
I'm new to this, got my machine setup and calibrated.
I'm trying to do a square but my corners are being cut slightly rounded. I would like them to be 90degree turns.
If there anyway to do this properly?
I'm using DevFoam pro and Mach 3.
Thank you
Hope someone can advice me please.
I'm new to this, got my machine setup and calibrated.
I'm trying to do a square but my corners are being cut slightly rounded. I would like them to be 90degree turns.
If there anyway to do this properly?
I'm using DevFoam pro and Mach 3.
Thank you