Hello Guest it is March 28, 2024, 06:40:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - worxman

Pages: 1
1
General Mach Discussion / UC100 issues
« on: February 11, 2016, 11:01:17 AM »
I was using Mach 3 and a gecko 540 controller with an old PC that had a parallel port. I bought a UC100 so I could use a new laptop instead, running windows 7 64Bit. Got it all up and running except for homing of the X and A axis, which are my gantry. I can jog all 4 axis just fine, but when I home, only the Y and Z move. Then when I try to jog again, only the A axis will move. Next I went back to the old PC and parallel port and everything works just fine. I copied over the Mach files and all of the settings are the same between the two computers. Really need some help!

Pages: 1