1
General Mach Discussion / Need Help wiring C11 to Sunfar e300 VCD to control my Spindle.
« on: April 17, 2016, 11:45:44 PM »
~Fellow Community Members,
I could use a hand from anyone who has successfully wired a C11 Board to a Sunfar e300 VCD Inverter
Specifically I have this one
http://www.automationtechnologiesinc.com/wp-content/uploads/downloads/2012/05/VFD03.pdf
and it's controlling
http://www.automationtechnologiesinc.com/products-page/cnc-spindle/2200w-3hp-air-cooled-cnc-milling-spindle
I have successfully wired the spindle to the VCD, I know this because when I put it into "Control by Keypad" mode it works perfectly.
However, I have not been able to wire the C11 to the VCD correctly. I can get the Spindle to engage via the board, but no speed or direction control.
If anyone has successfully wired this I would LOVE to get either a diagram or a picture of how you did it, (or merely a conversation would be a great assist ?)
Also I'm not positive I've got my Mach3 setup to send the right outputs.
What I am trying to achieve is get speed and direction control.
Thanks very much in advance.
David Hunt
267-221-4500
david@huntsolutions.com
I could use a hand from anyone who has successfully wired a C11 Board to a Sunfar e300 VCD Inverter
Specifically I have this one
http://www.automationtechnologiesinc.com/wp-content/uploads/downloads/2012/05/VFD03.pdf
and it's controlling
http://www.automationtechnologiesinc.com/products-page/cnc-spindle/2200w-3hp-air-cooled-cnc-milling-spindle
I have successfully wired the spindle to the VCD, I know this because when I put it into "Control by Keypad" mode it works perfectly.
However, I have not been able to wire the C11 to the VCD correctly. I can get the Spindle to engage via the board, but no speed or direction control.
If anyone has successfully wired this I would LOVE to get either a diagram or a picture of how you did it, (or merely a conversation would be a great assist ?)
Also I'm not positive I've got my Mach3 setup to send the right outputs.
What I am trying to achieve is get speed and direction control.
Thanks very much in advance.
David Hunt
267-221-4500
david@huntsolutions.com