Hello Guest it is March 28, 2024, 07:53:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - quachthanhtrung1112

Pages: 1
1
Mach SDK plugin questions and answers. / Re: Impact engraving plugin
« on: January 25, 2016, 11:26:14 AM »
My config: Steps per:32, (driver 1:16). feedrate 9000 (default òf the plugin), enable port 17 (connect to laser low active wire) digit trigger, velocity: 1000, accelerate: 300, dir pulse: 1us, kernel : 25kH
I really can not figure out the problem. Hope from ur help now, can u tell me how many way to increase the power, so I can adjust it to check the problem
My Co2 laser (in testing)
https://scontent-hkg3-1.xx.fbcdn.net/hphotos-xaf1/v/t35.0-12/12646671_10205409192494765_4904210436940320729_o.jpg?oh=5b3a406891e59c2cd9cdc77eb85b61fc&oe=56A829C6
Thanks so much.
 

2
Mach SDK plugin questions and answers. / Re: Impact engraving plugin
« on: January 25, 2016, 05:43:35 AM »
Thanks for ur reply
   U mean that, there is no solution for this case, so sad.
  My Laser is DIY CO2 Laser,  ratio is 1:1 ( Steps per : 32). If it's slow it's OK to me
Thanks.

3
Mach SDK plugin questions and answers. / Re: Impact engraving plugin
« on: January 24, 2016, 11:08:39 PM »
Hi Tweakie,
     I have just test your plugin, everything works well except that the power of laser is weak ( I have turn up it to max using potentiometer and test without plugin OK).
Can u tell me how many can we increase the power of laser
THanks so much.

Pages: 1