Hello Guest it is March 28, 2024, 05:54:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bigal11

Pages: 1
1
General Mach Discussion / Re: Z limit switch triggered
« on: January 22, 2016, 01:59:04 PM »
I'll have a look at that route and post any results. tks

2
General Mach Discussion / Re: Z limit switch triggered
« on: January 22, 2016, 01:22:22 PM »
I tried deleting that line.
The toolpath doesn't even make it to that line. It trips the limit switch on the preperation move.
I went back over some previous items and they all have a line with G43.
At a loss still.

Al

3
General Mach Discussion / Re: Z limit switch triggered
« on: January 22, 2016, 12:40:57 PM »
Thanks
I notice 1 of first lines has a G43 H1 Z.25
How do I correct this?


4
General Mach Discussion / Z limit switch triggered
« on: January 22, 2016, 11:38:52 AM »
Hello all,
I'm having some trouble with the z axis limit switch being triggered when i start a toolpath. I set my home limits. everything is fine. When i start a toolpath the spindle moves up untill it hits the limit switch, stops and then i have to press reset to continue the toolpath. I tried debounce up to 5000 with no luck. This has only been happening for about a month now.
Any help would be appreciated.

Al

Pages: 1