1
Spanish / Re: Pierdo pasos a baja velocidad pero no así en alta
« on: June 22, 2017, 01:38:15 PM »This problem could possibly be caused by electrical noise. Try increasing the Debounce Interval (Config. / General Config.) to 4000 and see if this makes a difference.
(my apologies that I do not speak your language).
Tweakie.
Thank you very much for answering my question. Let me tell you that I found the problem, I decreased speed a lot. And acceleration. Besides the x-axis was skidding. I did a macros to subtract the actual position compared to the end of the process, that helped me to calibrate the motors at the maximum possible speed. The electronic card has no noise, I design the noise filter because the spindle also made me lose steps. Certainly my computer is a bit slow, so everything is fine and I can only improve it. Thanks again.