Hello Guest it is March 28, 2024, 09:07:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KatzYaakov

511
Mach4 General Discussion / Re: Changing G54 inside script
« on: June 23, 2019, 01:32:21 PM »
Hayley664
its not good solution for his specific machine
because he must have at least 2 "homes" right and left(most have 4 ,but 2 its must)
so he cant block his homes acording tool number
i think only solution for him its G52
and create m function ,and inside make the table with offset per drill bit

512
Mach4 General Discussion / Re: Changing G54 inside script
« on: June 21, 2019, 03:33:30 AM »
chaoticone
jelle machine is not typical cnc to engraving
its cal PTP and its use in furniture industry
and gcode much more complicate ,also have many I/O need control while run
program mostly come as close file that we have label on part .scan the barcode and run
and second option its by parametric programs that just change parts size and all machining change according
there also issiue there about right side and left side(mirror) so i think your
suggest its just in time
and its will be very hard to write gcode by hand
must have some cad cam

513
Mach4 General Discussion / Re: Changing G54 inside script
« on: June 20, 2019, 07:43:53 PM »
i forget also you need look for sensors like horizontal driil up,or drill head up

514
Mach4 General Discussion / Re: Changing G54 inside script
« on: June 20, 2019, 07:42:35 PM »
jelle i think you waste time with try use with tool table
dont forget you have many other cycle to run ,not only move axis
run the motor,drill head down,bit drill down(in many case need more then 1 )
if horizontal need also add more
so i think you batter think about M function with G52 inside
similier as Garham suggest
yaakov

515
Mach4 Toolbox / Re: Enable Soft Limits via Script
« on: June 20, 2019, 05:25:37 PM »
did you get any answer?
i have same problem must control this from code
thanks

516
Mach4 General Discussion / Re: Changing G54 inside script
« on: June 19, 2019, 06:17:53 PM »
hi jelle ,i did it with G52
ach time i need drill i have the G52 in the script ,but you must not forget reset it when finish the script
good luck

517
Mach4 General Discussion / Re: Dust hood
« on: June 03, 2019, 01:20:24 AM »
Why not use pokeys cnc ? Have 24 inputs ,i not work at pokeys i just use it and interesting why use ESS in that case?

518
Mach4 General Discussion / Re: Pokeys 57CNC board setup
« on: June 02, 2019, 06:07:40 PM »
some thing misunderstanding here
you answer you use Ethernet
 then after you said you use"DB25 IDC connector."
my friend this 2 kind of connection   


519
when i run mach from external app c# i run the program and when finish this program i want get respone(event) that tell
me to the c# app that this file finish and i can start run the next file
thanks

520
Mach4 General Discussion / Re: Dust hood
« on: May 31, 2019, 11:38:27 AM »
hi
i little confuse ,before you said you use ESS  now you write pokeys
maybe mistake?