Hello Guest it is March 29, 2024, 04:23:41 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KatzYaakov

341
Mach4 General Discussion / Re: UC300ETH Analog Output 2 setup
« on: September 25, 2020, 02:50:37 AM »
the main spindle and "live tool" activate same time?

342
Mach4 General Discussion / Re: UC300ETH Analog Output 2 setup
« on: September 24, 2020, 02:52:32 AM »
just question ,for what you need 2 analog output?

343
Mach4 General Discussion / Re: No Official Update since August 2019 ?????
« on: September 23, 2020, 12:48:43 PM »
i try one of  the last Development version,but always error messege and crashes
so i back to 4300
i use pockeys

344
Mach4 General Discussion / Re: Mach4 probe macro
« on: September 02, 2020, 10:53:11 AM »
best way to be sure is always print out all numbers ,as error line then its like report for all yours cycle,i also print at the end the old value and new value to cheack if diferent seem normal

345
Mach4 General Discussion / Re: Running Mach 4 ver.2 on Windows XP
« on: September 02, 2020, 01:57:02 AM »
why not win 10?
i use only win 10 ,never have problems (only the desire of microsoft to control our life ,like to push you "one drive " ,but this...)
also if you add some other device ,like printer...always have driver ,so i think bater go with win 10 64 bit

346
if you want you can chat with me ,my watsapp 972504242775 yaakov

347
so ....change by notepad and test

348
which hardware?

349
Mach4 General Discussion / Re: MACH4 Tool Change script help
« on: August 26, 2020, 09:06:02 AM »
each step you said (like lift dust cover) i think have sensor to confirm ,action done(or not) then you also must consider that sensor in other
action(like homing)
you also need decied what do if one of every each action didnt compleate
then you have 2 sensors inside spindle
what i mean to say its not "help" if you have specific question im sure this forum its correct place
but script like this ,can take whole day(including testing, and as i described give solution for any unplan situation)
if you want save money ,try read the manual ,there basic ATC script
good luck

350
you can at first step  ,change this by notepad and test
but i also suggest you use same tool ,same program(more or less) to be sure the nc file its the problem