Messages

331

Mach4 General Discussion / Re: Surface map Wizard not working

« on: October 15, 2020, 01:05:33 AM »

thks,do you have sample file?

332

Mach4 General Discussion / Re: 5 axis, crossing the finish line. need a tiny bit of direction pointing

« on: October 14, 2020, 04:53:37 PM »

please send me small sample of yours gcode

333

Mach4 General Discussion / Re: Surface map Wizard not working

« on: October 14, 2020, 12:53:13 PM »

do you know the .dat file format?where is x,y,z ?

334

Mach4 General Discussion / Re: Surface map Wizard not working

« on: October 14, 2020, 10:41:26 AM »

second point need consider ,i need divied any segment to many small segment(can customize it ,let user decide what min segment size) ,so you need consider the files size if no problem

335

Mach4 General Discussion / Re: Surface map Wizard not working

« on: October 14, 2020, 10:34:48 AM »

one question ,when you want map the surface ,do you consider surface is flat but not parallel to table?
or its should be blend surface between several curve lines?

336

Mach4 General Discussion / Re: Mach 4 losing Home position

« on: October 14, 2020, 01:49:53 AM »

in mach you can see the "yellow box" with soft limit and the tool path ,so you can see if yours origin is "move"
i think also its tell you which line is the problem so you can understand which axiss make that
do you use G54 or working only by machine origin?

337

Mach4 General Discussion / Re: My tool runs off

« on: October 14, 2020, 01:41:18 AM »

what do you mean "tool left the programed path" do you mean that you see on screen exactly what real happened?("tool run off in a random direction")
or you see on screen that every thing is ok?(in that case craig full corect its look like some electric issue)

338

Mach4 General Discussion / Re: Surface map Wizard not working

« on: October 14, 2020, 01:34:06 AM »

if its very important  ,i think i can create pp that will get the data from the .dat file pass on the nc file and will calaculate the new z and rewrite the new nc file

339

Mach4 General Discussion / Re: 5 axis, crossing the finish line. need a tiny bit of direction pointing

« on: October 14, 2020, 01:28:15 AM »

its not only Z its suld be also X and Y ,its kinematic,you must divide yours tool path to multy small lines ,then calculate each position according the A and B the new X Y Z ,i think mach not support this
i thoght do this in the past but until now no need because my client use SolidCam that already have Tcp(tool  center point)
but if you need this develope i think i can help you

340

Mach4 General Discussion / Re: UC300ETH Analog Output 2 setup

« on: September 25, 2020, 09:42:37 AM »

Sorry , but i didn't understand yours need,can you send some pictures of yours machine,or any electrical diagram