321
Mach4 General Discussion / Re: Machine Freezes Followed by Unwanted Offset
« on: November 25, 2020, 07:01:37 PM »
i dont think its pc issue ,because pc or buffer problems not loose position ,maybe just give you deley
its sound more like the worst word in control system"noise"
in any case ,which hardware do you use?
check all yours ground
avoid ground loop
ground all "0" from all supplier to the main ground
try use Ethernet not usb cat7 cable
its sound more like the worst word in control system"noise"
in any case ,which hardware do you use?
check all yours ground
avoid ground loop
ground all "0" from all supplier to the main ground
try use Ethernet not usb cat7 cable