Hello Guest it is March 29, 2024, 10:32:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KatzYaakov

221
Mach4 General Discussion / PMC lua script run in any case
« on: June 25, 2021, 11:44:16 AM »
i try use pmc with script
i put the lua as "coil" and then "contact " before with some condition
what i get is that the script not consider any condition nd run in any case
i also try put "open circiut" befor the the coil but same problem
***why pmc crash so fast?

222
Mach4 General Discussion / analog input by pmc
« on: June 25, 2021, 06:22:27 AM »
i use pokeys
and pokeys have in there instruction how manage analog input to control Fro Or Rro by add
"Do file" on the main plc and add lua file
my question is ,because i start use already pmc ,maybe its batter use also pmc for this uses?
is it save time?

223
check on yours plug in if its use limit

224
Mach4 General Discussion / pmc -parallel line how to do?
« on: June 15, 2021, 06:53:55 AM »
hi
i start test use pmc and its  quit help in some event handler using

but i try do multiply coil in parallels ,but cant find how do it
please if some one can explain

225
Mach4 General Discussion / Re: External button "Enable"
« on: June 14, 2021, 07:33:48 AM »
for example last test i had problem with pokeys relay
that didnt work(its almost never happened ,but... can) so i have head ace until i understand its hardware problem

226
Mach4 General Discussion / Re: External button "Enable"
« on: June 12, 2021, 07:56:04 PM »
i have in my machines about 50 outputs ,so i must have some way to debug when have problem

227
Mach4 General Discussion / Re: External button "Enable"
« on: June 11, 2021, 07:18:28 AM »
i test now ,if i not map output its not work
i use pokeys
if not map the output see nothing on diagnostic

228
Mach4 General Discussion / Re: External button "Enable"
« on: June 11, 2021, 12:51:37 AM »
first its real good news you still with us
about PMC ,because PMC not map the input ,can i use both ,PMC and Lua (with map)?
the pmc run immediately when Mach start up?(like plc)
thks a lot yaakov

229
Mach4 Plugins / Re: XHC WB04 plugin
« on: June 10, 2021, 03:34:56 PM »
when you activate the plug in you will get screen with the remote photo to define remote function
its work quit nice
steve did great job
very bad he disappeared last month


230
Mach4 General Discussion / Re: External button "Enable"
« on: June 05, 2021, 02:34:26 PM »
is steve leave this forum?no real help here ,no real help on mach suport