3
« on: January 21, 2016, 11:07:27 AM »
Hello all I am a new b and looking for some information. I have an older PC-2-Route Model M2 V1.9 board made by sound logic that I am using to interface with my router. I have look for a manual for this but I guess its to old. It has a 6 pin connection on it for a mpg and i was hoping some one could help me figure out hot to hook it up. The mpg has 5V,0V,A,B, on it ( A&B are square waves output) it also has control for .001 and .010 on it. My questions are how to i figure out how to hook up what wires to the pins and then can i use one of the plug in to run this or will I have to wright my own brain to run it.
here is a pic of my mpg
O posted this once but not sure if i did it right. trying again.
Thanks for any help Tom