Hello Guest it is March 28, 2024, 08:58:59 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - onlyaman

Pages: 1
1
General Mach Discussion / Re: need help with MPG
« on: January 21, 2016, 01:50:55 PM »
here is a pic of my mpg

2
General Mach Discussion / Re: need help with MPG
« on: January 21, 2016, 12:52:01 PM »
Ok I will thank you. I want to sure if I posted my first post right. Didn't want to have mutable postings.

3
General Mach Discussion / need help with MPG
« on: January 21, 2016, 11:07:27 AM »
Hello all I am a new b and looking for some information. I have an older PC-2-Route Model M2 V1.9 board made by sound logic that I am using to interface with my router. I have look for a manual for this but I guess its to old. It has a 6 pin connection on it for a mpg and i was hoping some one could help me figure out hot to hook it up. The mpg has 5V,0V,A,B, on it ( A&B are square waves output) it also has control for .001 and .010 on it. My questions are how to i figure out how to hook up what wires to the pins and then can i use one of the plug in to run this or will I have to wright my own brain to run it.

here  is a pic of my mpg

O posted this once but not sure if i did it right. trying again.

Thanks for any help Tom

4
General Mach Discussion / keyboard control
« on: December 29, 2015, 06:07:13 PM »
hello
 I am having a strange problem with my keyboard arrows and controlling my gantry. The up and down arrows are moving my x axis and right and left are moving my y axis. If I use the tab key to bring up the control panel it is moving correctly. (Z+ Z- Ect.) I have tried to reassign the hot keys and even tried assign them backwards to see if this would change the problem. I not sure if this is just a bug with Mach what. Everything else runs fine. Just wonder if anyone has run across this.

Thanks for your help.
 Tom

5
Hello all
 I am new here and just wanted to say hi. I am also looking for some help with a problem I am having. will try to post it in the right area.

 Thanks all

Pages: 1