1
General Mach Discussion / Can I go back at some point and start over?
« on: May 26, 2016, 10:16:45 AM »
Hey Guys,
Have been using my cnc foam cutter for almost 6 months now.
Unfortunately came to a problem - the wire tore and I am in the middle of a cutting job.
Can I move the DROs (the arms) backward to some positions and after I replace the wire to start over from there?
Thank You!
Nick
Have been using my cnc foam cutter for almost 6 months now.
Unfortunately came to a problem - the wire tore and I am in the middle of a cutting job.
Can I move the DROs (the arms) backward to some positions and after I replace the wire to start over from there?
Thank You!
Nick