Hello Guest it is March 28, 2024, 04:39:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - CraftMa

Pages: 1
1
General Mach Discussion / Re: Auto Squaring Gantry
« on: December 21, 2015, 09:53:45 AM »
You need two switches for Mach3 to square the gantry for you. You basically just set up the home switches in Ports and Pins for both the Master (X) and Slave axis (A?), and when you home, each side should home independently to their own switch. You need to make sure to UNCHECK "Home Slave with Master" in General Config. You may also need to modify your Ref All script to use RefCombination() to get the two sides to move together.

However, I've heard from several people that auto squaring slaved motors doesn't work correctly with the ESS. I've never used one, so I can't confirm that. There is apparently some type of workaround. You might want to contact Greg at Warp9 to see if there are any issues.

Hi Ger21, I'm having a problem with this. When I uncheck home slave with master and save it when I come back it is always checked again.

Pages: 1