Hello Guest it is September 27, 2023, 02:12:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - defix

Pages: 1
General Mach Discussion / Re: Slave axis is not moving on G-code
« on: December 20, 2015, 04:01:04 PM »

Find software my new project, but i have in Mach3 same issue.
Loading sample G-code and it runs only the Y axis moves, slave A not moving at all?In jogging mode Y and A moves together nicely.
Using  breakout board (STB4100) and ST-40-45-A1 controllers.

All best,

Pages: 1