11
Show"N"Tell ( Your Machines) / Re: The Laser Project.
« on: January 30, 2011, 08:31:17 AM »
Thank you I'll try that one out soon. There is some left before I can start playing around with mach 3.
1. Making a holder for the focus lens.
2. Air assist for protecting of the lens.
3. Setting up some kind of limit switches. Don't know what to use yet for this high speed application.
4. Some PWM regulation for the four PAPST fans to cool the laser (they are a bit overkill for shorter runs - 18Watt each - and make a lot of noise).
5. Knock a hole in the brick wall for poisonous gases to get out.
6. other stuff that will come up
1. Making a holder for the focus lens.
2. Air assist for protecting of the lens.
3. Setting up some kind of limit switches. Don't know what to use yet for this high speed application.
4. Some PWM regulation for the four PAPST fans to cool the laser (they are a bit overkill for shorter runs - 18Watt each - and make a lot of noise).
5. Knock a hole in the brick wall for poisonous gases to get out.
6. other stuff that will come up