Hello Guest it is March 28, 2024, 08:17:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ballistic42

Pages: « 1 2 3 4 5 6 7 8 9 10 11 »
31
I had to rename them to send again on the forum.

32
i did what you said and the LED on the ATC screen works.  I need to now try to figure out what I am doing wrong in the brain.  Here the XML is and the brain sorry about that I gave you an old one.

33
My brain in fried trying to figure this out....

34
Hood thanks!

35
I am sorry what i meant to say is when the Pin on the BOB turns on because the pressure sensor is open the UserLED1061 should be off.  When the pressure drops below the 80PSI the bob LED turns on but the UserLED1061 is not turning on. 

36
when the brain is active, when air pressure is below 80psi and the pin on the BOB turns on My UserLED on the ATC screen should turn on YES or NO?  When the pressure sensor is satisfied the BOB pin LED is OFF when the Pressure drops below 80PSI the BOB LED should come on which it does.  Why can't I get the UseLED1061 to light up when the BOB LED is ON?  This is the problem.  There is a disconnect somewhere in the logic.  I have to be missing something very simple.

I appreciate your help

Jeff

37
Are you using the Macro that you wrote at the beginning of the post?

38
Hood,  I don't understand how you got that to work!  I made the brain look like this,

OEMTRIGGER11:0--------------------Invert flip signal--------------------OEMLED1061:1

For some reason the UserLED1061 I made in machscreen is not lighting up.  I can see the port and Pin on the M21 board working so I know its getting the signal just not showing on the screen with the LED?

Jeff

39
Brains Development / OEMTRIGGER#11 USERLED1061 HELP!!!
« on: April 16, 2016, 01:48:23 PM »
I am using  OEMTRIGGER#11 as an input for a pressure sensor.  When the psi drops below 70psi in the system I am wanting to activate UserLED1061.  I have tried to make a brain for it but cannot get it to work so I am for sure doing something wrong.  I have the UserLED made and is called UserLED1061.  Here were the steps in the brain,

Input - Oemtrigger11 - no operation - UserLED1061

When the Pin becomes active the UserLED1061 should light up but it is not?

Any help would be awesome.

Jeff

40
Hood, I have the LED working on the M21 board but am trying to get an LED to work on my ATC screen to tell the user the ATC SYSTEM PRESSURE IS LOW.  I made the LED in machscreen with the User LED # of 1061.  The UserLED is attached to OEMTrigger11.  I tried making a brain to get the LED to light up on the ATC screen but have had no luck at all.  When the system pressure drops below 70PSI I have it set on OEMTRIGGER #11 and  Pin 3-7 will light up on the M21 board, when that happens I would like my ATC low psi LED to light up as well.

Any help would be awesome.

Jeff

Pages: « 1 2 3 4 5 6 7 8 9 10 11 »