1
General Mach Discussion / THC IN A PLASMA TUBE MACHINE
« on: November 02, 2015, 07:01:38 PM »
Hi!! my name is Javier Im from Argentina. I build a plasma tube machine (for square and round pipe). So my question is: My idea its to install a Proma THC control, but whats happens when I cut square tubes?
Well, Mach3 drives X, Y, Z and A axis in my machine, so when I cut square tubes Mach drive Z axis in the corner of the rotations... If I install the Proma control.. maybe send a signal (up or down) when Mach is sending too a signal (when the square tube is rotating) ... I think thats is a problem?... I am wrong?
Maybe I wrote in a wrong discussion?
Sorry I' am new here.
Thanks very much for all.
Regards from Argentina!
Javier
Well, Mach3 drives X, Y, Z and A axis in my machine, so when I cut square tubes Mach drive Z axis in the corner of the rotations... If I install the Proma control.. maybe send a signal (up or down) when Mach is sending too a signal (when the square tube is rotating) ... I think thats is a problem?... I am wrong?
Maybe I wrote in a wrong discussion?
Sorry I' am new here.
Thanks very much for all.
Regards from Argentina!
Javier