1
Mach4 General Discussion / Mach3 and Mach4 on same machine?
« on: February 10, 2018, 11:30:43 PM »
I'm currently running Mach3, and Mach4 looks pretty enticing. I'd like to try it, but I'm pretty much in full production mode and cannot take my machine out of service to play with new software.
Am I correct in thinking that Mach3 and Mach4 can both be on my computer, and either can run my system? Each will (hmmm, my ignorance is showing...) initialize my ESS properly, without messing up settings for the other program? If changing between Mach3 and Mach4, I'd shut down my control system. I can play with Mach4 when I'm done with my work for the day?
I'm running an ESS and PMDX 126.
Thanks!
Am I correct in thinking that Mach3 and Mach4 can both be on my computer, and either can run my system? Each will (hmmm, my ignorance is showing...) initialize my ESS properly, without messing up settings for the other program? If changing between Mach3 and Mach4, I'd shut down my control system. I can play with Mach4 when I'm done with my work for the day?
I'm running an ESS and PMDX 126.
Thanks!