Topics

1

Galil / Spindle control with Galil controller: 0 to 10V

« on: December 04, 2015, 12:03:25 AM »

Dear All ,

       I am using Galil 2143 controller with Mach3. I have installed Galil plugin and configured three axes for servo motor and the 4th Axis for spindle control. My servo motors are running fine. But I am facing problem with Spindle axis, Galil controller is not giving 0 to 10V output for the VFD to control the spindle speed. I mapped Mach3 "S" axis to the Galil  "W" Axis and checked the "Spindle is 0 to 10V". Please help me to setup and run the VFD Spindle with 0V to 10V output from the Galil .

Note: SM Jumper for W axis is not used.
 

2

General Mach Discussion / Setting Acceleration and deacceleration time values in mach3

« on: October 08, 2015, 02:33:41 AM »

Dear All,

       I need to set Acceleration and deacceleration time for linear interpolation in mach3. I have tried with Mach3>config>Motor Tuning> Acceleration , but no effects on the vector acceleration and deacceleration in linear interpolation. can anyone tell me how to set the accel. and deaccel. time values in mach3 ?