41
General Mach Discussion / Changing Axis Orientation
« on: October 07, 2015, 06:43:50 PM »
Hi Everyone,
Firstly, thanks for having me on board the forum.
Not sure if this belongs in this sub forum, but here goes.
I have done some googling to see if I can find an answer to this, but the best I could find was to do with changing the direction of the homing.
Basically, My Mill currently homes in the right direction, I.E - Bottom left corner in X & Y axis. But as I move it in positive Y and X (based on conventional right hand rule) my X and Y value on the mach screen go negatively.
Is there a way of switching this to the currect convention
Many thanks
Rusty
Firstly, thanks for having me on board the forum.
Not sure if this belongs in this sub forum, but here goes.
I have done some googling to see if I can find an answer to this, but the best I could find was to do with changing the direction of the homing.
Basically, My Mill currently homes in the right direction, I.E - Bottom left corner in X & Y axis. But as I move it in positive Y and X (based on conventional right hand rule) my X and Y value on the mach screen go negatively.
Is there a way of switching this to the currect convention
Many thanks
Rusty