Hello Guest it is March 29, 2024, 08:15:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BUiTiG

Pages: 1
1
Hi mark,
I have the newest plugin installed. Now, as well with the last two older versions, the mach is hanging.

The reason for three mpg's is, that I can use my CNC Machine also manually.
Thanks

2
Mach4 General Discussion / ESS Diagnostics System not responding
« on: May 26, 2017, 06:14:05 AM »
Hello everbody,

I want to install 3 Encoder's (Handwheels). One for X axis, one for Y axis and one for Z axis.
I set up all input signals in the ESS plugin, as well as in mach.
Every Encoder did work well, but with every encoder, just the x axis is moving.
I found out, that in the ESS Diagnostics the default setting are for every encoder is "Motor 0".
I will change this, but i can't. Every time when I open ESS Diagnostics, the system is not responding. I have to restart the PC and power off the ESS.

Is there any other chance to go into ESS Diagnostics?

Thanks
Andreas

Pages: 1