131
General Mach Discussion / Re: Unspecified failure message
« on: June 23, 2007, 11:01:44 PM »
Hi All,
This drove me nuts until I discovered the only way to make it go away was same as Involute's fix. That is, close Mach3, then reboot the computer. Whilst this in not very satisfactory, it appears to be a workaround.
The other symptom that I notice while the computer was in this "mode" was that M3 S*********x commands from the MDI also resulted in the same error message and the the spindle motor would not start.
Thanks for the feedback. It is good to know that others are experiencing the same problem.
Kind Regards
Chrisjh
This drove me nuts until I discovered the only way to make it go away was same as Involute's fix. That is, close Mach3, then reboot the computer. Whilst this in not very satisfactory, it appears to be a workaround.
The other symptom that I notice while the computer was in this "mode" was that M3 S*********x commands from the MDI also resulted in the same error message and the the spindle motor would not start.
Thanks for the feedback. It is good to know that others are experiencing the same problem.
Kind Regards
Chrisjh