This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Filename | Downloads | Message | Posted |
---|---|---|---|
IMGP1054.JPG | 1032 | Guess what these are used for | September 18, 2010, 12:16:24 AM |
IMGP0748.JPG | 554 | Re: Front & rear toolpost in Turn 42.020 | August 27, 2009, 10:04:09 PM |
Handle Crank_D.dxf | 328 | Re: LazyTurn | July 11, 2009, 06:44:02 AM |
Guess What Assy.pdf | 666 | Guess what these are used for | September 18, 2010, 12:16:24 AM |
General Config Settings.png | 1026 | Re: Hair already gone. pulling teeth out next...spindle tuning issues... | September 22, 2010, 04:58:37 PM |
G95 Motion Closeup.png | 830 | Re: Mach3 Turn CSS Mythbuster | November 13, 2013, 10:00:29 PM |
G83 Peck Drill Template.txt | 436 | Lathe G83 Peck Drilling Problem | October 17, 2009, 07:52:35 PM |
Fitting Piston and Rings - Almost There.JPG | 495 | Re: My latest longer term project | December 23, 2012, 04:27:52 PM |
File without Offset.txt | 273 | Cutter Offset Learning Problem | September 27, 2010, 10:23:09 PM |
File with Offset.txt | 273 | Cutter Offset Learning Problem | September 27, 2010, 10:23:09 PM |