Hello Guest it is June 13, 2024, 10:21:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - DonKijote

Pages: 1
Also, am I supposed to connect the neutral coming off the motors to the chasis of my machine?

I connected the neutral coming off of the 110, to the chasis on my control box. Is that correct?

Then I put that neutral on an empty block, should I ground that neutral to my machine aswell?

Hello everyone this is my first post here.

I am troubleshooting this mill, using gecko 320x and a smoothstepper board, with a power supply kit from automation technologies.

Motors heat up very fast when on idle, and when i try to jog continually i get steps, even with the MPG i still dont get continuous movement. and sometimes it goes the opposite direction a couple of steps.

Any ideas?


Pages: 1