Hello Guest it is November 29, 2021, 06:26:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - loisftw

Pages: 1
General Mach Discussion / Re: How to disable E-Stop on Limit
« on: March 20, 2016, 09:44:19 AM »

Thank you!


General Mach Discussion / Re: How to disable E-Stop on Limit
« on: March 19, 2016, 09:02:40 PM »
Yes! The Limits should stop the axis moving in this direction, but should be movable wihout reset and the Override Buttons in the other direction.

General Mach Discussion / Re: How to disable E-Stop on Limit
« on: March 19, 2016, 01:01:45 PM »
Exactly, each Axis has it own Input for Limit+, Limit- and Home.
The E-Stop Limits are connected in series and then to the Pilz Module.

General Mach Discussion / How to disable E-Stop on Limit
« on: March 19, 2016, 10:41:01 AM »

I have retrofitted an early 80's 18kW CNC Lathe with Mach3, Panasonic Servos and CSMIO.
I have got nearly everything working, but i have the following issue:

My Lathe has got professional "Euchner" Limit+, Limit-, E-Stop and Home Switches.
That means, when the Machine is on the Limit it does not have to trigger the E-Stop, because the E-Stop button is a few Millimetres later.
(And the E-Stop is connected to the Pilz Safety Module, so its really safe)

I want to use the "hard" Limits because eg. before Ref. drive the Soft Limits are in the wrong place.

Is there an Option without Brains and Macros?

Yours loisftw

FAQs / MPG is not recognised
« on: June 08, 2015, 04:06:20 PM »
Hello Guys :)
I am new here. D:

I have retrofitted a 18kW Lathe from the 80's with CSMIO/IP-A and Mach3.
I was able to solve the most problems, but the MPG is making me nervous. :o

The encoder in the MPG is connected to the CSMIO Board and gives a nice signal out (Attachment).
I am also able to read the signal in Mach3 out.

For testing I configured the two Pins on the B and C homing input and in the diagnostic screen I can see the same action like in the attachment

I have configured the MPG in Port's and Pin's on Port 10 and Pin 12+13
On the CSMIO Board its on the Pins 12+13 (with zero counted)

When I switch on the MPG mode (and select the axis) and turn the MPG the LED's on the Board are lighting..
But nothing moves.

If I go to the MPG calibration wizzard and I klick e.g. on "Call Detent Size" and turn the MPG one step nothing happens. When I click calculate it calculates 0.

I hope anyone can help me.

Yours Burkhard

Pages: 1